Viking Filaments® rPETG (Recycled)

Viking Filaments Viking Filaments

SoluNOiD's own brand - Premium Filament properties

  • Made in Europe
  • Tolerance of +/- 0.05mm
  • PIPG - Recycled / Post Industrielt PET-G
  • More than 97% recycled material
  • Strong and Flexible
  • Odor neutral
  • Easy to print
  • Almost no warping and shrinkage
  • Note: 1kg roll!

More details

In stock online & store

  • 1kg

23,50 EUR

tax incl.

VIKING FILAMENTS RPET-G (RECYCLED PIPG)
An everyday filament out of the ordinary

Key Features:

  • Low warping
  • Very limited odor
  • Easy to print
  • High strength and flexible
  • Does not absorb moisture
  • Benefits from PLA and ABS in one combined product

It is recommended to use over 70 degrees on the building board during printing. If cracks occur during printing, reduce the speed of the filament cooler.

WHY CHOOSE VIKING FILAMENTS PET-G
PET-G is generally an equally easy material to deal with as PLA. It is a widely used material because:

  • It is easy to print with
  • It can be used for a wide variety of purposes
  • Is impact resistant
  • Dimensional / shape stable
  • Resistant to a lot of different liquids and oils
  • 1kg on the roll as opposed to 750g on many other brands

There is low humidity in the material. It can also be printed without drying it first. However, drying it will in any case lead to improved printing properties.

PET-G adheres extremely well to your building board. Whether it is PEI or Glass, or something completely 3. Therefore, you must be aware that you are using a so-called "release agent" such as. a traditional hobby glue stick. This ensures that there is a thin layer between the PET material and your building board where the model is built up. It helps that the workpiece is not super difficult to get off the building board after printing, and in the extreme consequence destroys your building board when removing the workpiece (ALWAYS REMEMBER TO LET YOUR BUILDING SHEET COOL BEFORE YOU REMOVE THE ITEM)

CLEAN BUILDING PLATE - ALFA & OMEGA
It is essential that the build plate is kept as clean and grease-free as possible. Many people find that their filament does not adhere well to the building board and uses glue and even hairspray.

Often, it's just a matter of cleaning your building board and keeping it clean. Start by cleaning your building board with dish soap, hot water and a scouring pad. Avoid touching the build plate while drying and reattaching the build plate to the printer. Then the building board is like new again. And after each print, wipe the building board with a cloth that has been poured a little isopropyl alcohol / isopropanol on. From time to time you can also pour a little isopropanol on the scouring pad and then scrub a little on the building board, and dry with a cloth. Then it's ready to go again!

If the above does not help, then there is a high probability that your nozzle's distance to the building board is not adjusted correctly. It may be too close or too far away. Use the paper method to roughly adjust, and then find a test pattern on e.g. thingiverse.com to print a single layer of square squares in all 4 corners and in the center. If they look the same, have a smooth surface, then the printer is adjusted correctly.

Here is the illustration of a wrong and a correct adjustment:

Source: prusaprinters.org

Brand Viking Filaments
Material PETG
Diameter 1.75mm
Diameter tolerance +/- 0,05 mm
Weight 1000g
Print temperature 230°C - 250°C
Heated bed required Yes
Recommended heated bed temperature 70°C - 85°C
Warehouse Store

Write your review

Write your review